rob

There is a way to shut down factory alarm .Driver side kick panel purple wire with yellow stripe. Disconnect battery ground wire, reconnect battery.

Got mine a few weeks back.Played with reading a few ECM I had.Finally got a chance today to use it. 2013 Chevy Cruze , took me about 30 min as this was the first one. Pretty simple process .

Used Autel to do Used ECM swap. Must start with orig ECM installed read info then transfer.Autel failed to program prox back to vehicle but Zed Full finishes the job.

Just did 2003 Impala using TIS . In Body under Radio ,Relearn.No need for Vin from donor car.Have done a few Cadillac.They removed the feature on some newer but if you go back a few years on veh selection it sometimes works.
Customer said old radio was draining battery so they disconnected it 10 years ago. Someone wrote no sound on old radio .Now selling car .buys radio from junkyard pays me to unlock it . Guess what radio on ,no sound.Look under rear deck at amplifier . All unplugged ! Plug in Radio works .Old guy happy can sell car now Can’t drive anymore !

Used Autel to do Used ECM swap. Must start with orig ECM installed read info then transfer.Autel failed to program prox back to vehicle but Zed Full finishes the job.

Used Autel to do Used ECM swap. Must start with orig ECM installed read info then transfer.Autel failed to program prox back to vehicle but Zed Full finishes the job.

Installed a new BCM in 2003 Impala today.Used Tech2Win to do set up.Set the Vin ,Country Code and the options by build tag.Didnt give a lot of options ,Daytime running lights,Auto lights ,police car.After set up you need to unlock the radio with the tech2 then switch over to Tis2000 and do a Security relearn.Start car all seems ok.Air bag light is out now but the Keyless entry does not work. Tried to program won’t take it.I used it to open trunk when I started ?Back in to setup on BCM turn on RFA and program fob in.How does RFA stand for Keyless entry ?
 

Installed a new BCM in 2003 Impala today.Used Tech2Win to do set up.Set the Vin ,Country Code and the options by build tag.Didnt give a lot of options ,Daytime running lights,Auto lights ,police car.After set up you need to unlock the radio with the tech2 then switch over to Tis2000 and do a Security relearn.Start car all seems ok.Air bag light is out now but the Keyless entry does not work. Tried to program won’t take it.I used it to open trunk when I started ?Back in to setup on BCM turn on RFA and program fob in.How does RFA stand for Keyless entry ?
 

Good tip.I have seen a few older cars show up
where they replace the skim with a used one and change the PCM vin to match the vin of the used skim.Screw everything up down the road .

Shop could not locate a ECM for the Isuzu .Picked up one for a Trailblazer. Reflashed with TIS 2000 .Everything went well security light out but would not start. Even though security light was out there was still a code for theft .Did a theft relearn and good to go.Dont always trust the light.

Shop could not locate a ECM for the Isuzu .Picked up one for a Trailblazer. Reflashed with TIS 2000 .Everything went well security light out but would not start. Even though security light was out there was still a code for theft .Did a theft relearn and good to go.Dont always trust the light.

Body control can be set with tech 2 or tech 2 win.BCM has to have vin and odo installed .
you may also be able to do BCM with Autel.Remember vehicle will start with non coded BCM a few times then it will lock.Cannot be unlocked.